Tools of the Trade – Component Placing

May 10, 2016

Recently we started a series on the components used to assemble a circuit board. The first issue was on dispensing solder paste. Moving down the assembly line, with the paste already on the board, the next step is getting the components onto the PCB. We’re just going to address SMT components in this issue, because the through hole assembly doesn’t take place until after the SMT components have gone through the process to affix them to the board.

Read the full article at Hackaday: Tools of the Trade – Component Placing

You can follow any responses to this entry through the RSS 2.0 Both comments and pings are currently closed.